Care & Cleaning; Troubleshooting - Glacier bay F51A1071CP Guía De Instalación Y Cuidado

Care and Cleaning
This faucet is designed for years of trouble-free performance. Keep it looking new by doing the following:
Clean periodically with a soft cloth.
Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.

Troubleshooting

NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks underneath the
handle.
The aerator leaks or has an
inconsistent water flow pattern.
The water will not shut off
completely.
Leaking from sink drain
at the base of the sink.
Possible Cause
The retainer nut has come loose
and the O-ring on the cartridge
is dirty or damaged.
The aerator is dirty or mis-fitted.
The rubber seat and spring is
dirty or broken.
Leaking from sink drain at the
base of the sink.
6
Solution
Tighten the retainer nut.
Clear or replace the O-ring.
Remove the aerator and check for
debris in the aerator screens.
Confirm that the rubber washer is
properly installed.
Remove the handle and cartridge to
check the rubber seat and spring.
Clean or replace.
Apply additional silicone sealant
to the beveled side of the drain
ange.
Retighten and test for leaks.