Tabla de contenido
Publicidad
•
PERMANENT/TEMPORARY BLINDNESS HAZARD!
Operators must control access to the beam within the
hazard distance or install the product at the height that
prevents exposure of spectators' eyes within the hazard
distance. The hazard zone must be no lower than 2.5
meters (US installations) or 2.0 meters (global
installations) above any surface upon which any persons
are permitted to stand and the horizontal clearance to
the hazard zone must be a minimum 1.0 meters.
•
EXTREME BRIGHTNESS! Do not place reflective objects in
the product light path.
The following diagram shows the zones for ocular and skin
hazard distances:
•
A—Hazard zone. The region of space where the
projection light from the laser-illuminated projector is
above emission limits for Risk Group 2. The light
intensity may cause eye damage after a momentary or
brief exposure (before a person can avert his or her eyes
away from the light source). The light may cause skin
burns to occur.
•
B—Hazard distance. Operators must control access to the
beam within the hazard distance or install the product
preventing potential exposure of the spectators' eyes
from being in the hazard distance.
•
C—No access zone. Horizontal clearance of the no access
zone must be a minimum of 1.0 meters.
•
D—Vertical distance to hazard zone. The hazard zone
must be no lower than 2.5 meters (US installations) or
2.0 meters (global installations) above any surface upon
which any persons are permitted to stand.
•
E—Represents the top view of the projector.
•
F—Represents the side view of the projector.
For information detailing the hazard distance for each lens, refer
to the Cinema 4K-RGB Installation and Setup Guide (P/N:
020-102710-XX) or Cinema 4K-RGB User Guide (P/N:
020-102712-XX).
For Installations in the United States
The following must be in place for laser-illuminated projector
installations in the United States:
•
The projection room shall be clearly identified by the
posting of laser warning and restricted access signs, and
Cinema 4K-RGB Product Safety Guide–CP4325-RGB, CP4330-RGB
020-103085-02 Rev. 1 (04-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
by restricting entry through physical means. The
projection room sign must display the warning "No direct
exposure to beam shall be permitted".
•
The Christie Laser Projection System Installation
Checklist must be fully completed after the installation
and sent to lasercompliance@christiedigital.com. A copy
can remain on-site. This checklist can be found as a
separate document in the accessory box with the
manual.
•
If installing in the US states of Arizona, Florida, Georgia,
Illinois, and Massachusetts, go to www.christiedigital.com
for additional regulatory requirements.
Power specifications
Item
Description
Voltage range
200 - 240 VAC
Maximum current 20 A
Line frequency
50/60 Hz
Technical support
•
North and South America: +1-800-221-8025 or
Support.Americas@christiedigital.com
•
Europe, Middle East, and Africa: +44 (0) 1189 778111 or
Support.EMEA@christiedigital.com
•
Asia Pacific: +65 6877-8737 or
Support.APAC@christiedigital.com
•
Christie Managed Services: +1-800-550-3061 or
NOC@christiedigital.com
Important Safety Information
5
Publicidad
Tabla de contenido
