LG A2UW18GFAB Manual De Instrucciones página 13

3
Please fix remote controller upper part into the
setup board attached to the surface of the wall,
as the picture below, and then, connect with
setup board by pressing lower part.
- Please connect not to make a gap at the remote
controller and setup board's upper and lower,
right and left part.
When separating remote controller from setup
board, as the picture below, after inserting into
the lower separating hole using screw driver and
then, spinning clockwise, remote controller is
separated.
- There are two separating holes. Please individu-
ally separate one at a time.
- Please be careful not to damage the inside
components when separating.
4
Please connect indoor unit and remote controller using connection cable.
5
Please use extension cable if the distance between wired remote controller and indoor unit is
more than 10m.
CAUTION
!
When installing the wired remote controller, do not bury it in the wall.
(It can cause damage in the temperature sensor.)
Do not install the cable to be 50m or above.
(It can cause communication error.)
• When installing the extension cable, check the connecting direction of the connector of
the remote controller side and the product side for correct installation.
• If you install the extension cable in the opposite direction, the connector will not be con-
nected.
• Specification of extension cable: 2547 1007 22# 2 core 3 shield 5 or above.
INSTALLATION OF WIRED REMOTE CONTROLLER
Please check if connector is normally connected.
Connecting cable
<Connecting order>
Wall Wall
Side Side
<Separating order>
Wall Wall
Side Side
Indoor
Unit side
13