Wiring - Phase Linear PCD161 Manual Del Usario

PCD161

WIRING

WARNING! Never combine (bridge) outputs
for use with 1 speaker.
WARNING! Never ground negative speaker
leads to chassis ground.
CAUTION: Failure to wire exactly as shown
may cause electrical damage to the radio.
Amplifier Wiring
Connect line out for optional
external amplifiers. The red
connector is for the right and the
white connector is for the left.
Gray
LF/AVG
White/Black (-) Gray/Black (-)
White (+)
LR/ARG
Violet/Black (-)
Green/Black (-)
Green (+) Violet (+)
Blue
Black
Yellow
+
FUSE
Red
RF/AVD
Gray (+)
RR/ARD
Antenna Connector
Power Antenna/
Amplifier Remote
Connect to power antenna
or amplifier. If not used, tape
bare end of wire.
Ground
Connect to ground terminal.
Memory/Battery
Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
Accessory/Ignition
Connect to existing radio
wire or radio fuse.
Fuses
When replacing a fuse, make
sure the new fuse is the correct
type and amperage. Using an
incorrect fuse could damage
the radio.