Installing The Removable Faceplate - Phase Linear PCD161 Manual Del Usario

INSTALLING THE REMOVABLE FACEPLATE

Faceplate Installation
To install the faceplate:
1. Slide the left edge of the front panel into the
radio.
2. Gently press the right side into place.
STEP 1
STEP 2
PUSH
Faceplate Detachment
To remove the faceplate:
1. Press the release button.
2. Pull gently on the right side of the front panel
to remove it.
STEP 1
3. For safekeeping, store the front panel in the
protective case provided.
Handling Precautions
• Make sure the front panel is right-side-up
when attaching it to the chassis, as it cannot
be attached when up-side down.
• Do not press very hard on the front panel
when attaching it to the chassis. No more
than light to moderate pressure is needed.
• When attaching the front panel, make sure it
is centered in the chassis frame and is
pressed straight into position.
• Do not drop the front panel.
• Do not put pressure on the display or control
buttons when handling the front panel.
• Do not touch the electrical terminals on the
front panel or main unit.
• Remove dirt or foreign substances with a
clean, dry cloth only.
• Do not expose the front panel to extreme
STEP 2
temperatures or direct sunlight.
• Keep volatile agents such as benzene,
thinner or insecticides away from the front
panel.
• Do not disassemble the front panel.
• When taking the front panel with you, please
use the supplied carrying case to protect the
panel from dirt and damage.
• Make sure there is no dust or dirt on the
electrical terminals on the back of the panel
as this could cause intermittent operation or
other malfunctions.
PCD161