DVO GARNET Guía De Configuración Del Manual Del Propietario página 10

ENGLISH
CABLE INSTALLATION Internal Routing
5. Route cable housing from your lever into your frame's internal routing port.
6. Push the housing through the frame until
the housing emerges from the seat tube as
shown in the image.
Measure the required length of cable and
7.
cable housing by turning your handlebars
to their most extreme turned position.
8. With the handlebars turned, you need ap-
proximately 2 inches (50mm) of exposed
cable emerging from the seat tube. (As
shown) If it is too long, trim the housing.
DO NOT trim the cable itself!
9. Once you have the correct housing length,
now it is time to set the correct cable
length. The protective cover on the bottom
of the seatpost has a measuring indicator.
Use this to measure an 11mm gap from
the housing to the end of the cable.
10
GARNET DROPPER OWNER'S MANUAL & SET UP GUIDE
11mm