Beta 599 DGT-A/20 Manual De Instrucciones página 16

STEP 1: VALUE STORAGE
Value storage: M1
Value storage: M2
Value storage: M3
Value storage:M9
NB: Up to 9 stored values can be set
STEP 2: UNIT SELECTION
Presetting Unit: Nm
Unit Selection: in-lb
Unit Selection: ft-lb
Unit Selection: ft-lb
Unit Selection: kg-cm
16
Press
Press
Ÿ
Ÿ
Ÿ
*Notes 1, 2
Press
Press
Press
Press
STEP 3:
SET TORQUE VALUE
Presetting Torque Value
Press
Increase Max. Torque Value
Press
Decrease Max. Torque Value
Nota:
1. If appears, that means more than 110%
torque as stated in the specifications has been
applied to this wrench.
The wrench will start working again after a few
seconds; however, it should be checked for
calibration at a Beta authorized centre as soon
as possible.
2. The function "Unit Selection" is sequential
STEP 4:
PEAK HOLD / TRACK MODE SELECTION
Track Mode
Long Press
Set Peak/Track Mode
Press
Set Peak/Track Mode
Press
for Selection