Angle Inversion And Selection Pivot; Starting-Up And Using The Machine; Plugging The Machine To The Electricity - Sima DEL-32 Manual De Instrucciones

6.3 ANGLE INVERSION AND SELECTION PIVOT.

The inversion pivot "P" is used to select the plate rotation angle. Depending on the direction of rotation of the
plate that we select (clockwise or counter-clockwise), we will have to insert the pivot to the left or to the right of the
inductive sensor "S1" and "S2".
Sensor S1, is to stop the bending plate when the pivot passes over it.
Sensor S2, is to stop the bending plate when it returns to its original position.

7. STARTING-UP AND USING THE MACHINE.

WARNING: All safety recommendations must be followed, either the ones mentioned in the present user manual or
those complying with all labour risks prevention norms in every location.
WHEELWORK: SIMA bending and combined machines do not need any wheelwork operations as they are specially
designed to obtain the maximum performance from start.
NORMAL USE OF THE MACHINE:
The bending machines have been designed for bending and cutting flat and reinforced steel bars for use in the
structure and other construction. Each other use that has not been expressively indicated is considered abnormal. Any
tool or accessory added or amended without written authorization from the manufacturer is considered inappropriate
and dangerous. If any damage or injury is caused as a result thereof or by misuse of the machine, SIMA S.A. exempts
all responsibility as manufacturer. The machine must be installed on a plane, firm and horizontal surface and the ground
should not be soft.
This machine MUST NOT BE USED IN THE RAIN. Cover with waterproof materials. If the machine has
been exposed in the rain check before connecting the electrical parts are not wet. ALWAYS WORK WITH
GOOD LIGHTING CONDITIONS.

7.1 PLUGGING THE MACHINE TO THE ELECTRICITY.

The extension cable used to feed the machine needs to have a minimum section of 4x2.5 mm
long. For a superior distance 4x4 mm
of 3P+T or 3P+N+T compatible with the machine switch and in the other end, one normalised aerial pin of 3P+T ó
3P+N+T compatible with switchboard exit.
Machines with electrical motor should always be connected to a normalised switchboard that
disposes of a magneto-thermal switch and a differential in accordance with the characteristics of
the motor:
3Kw / 4 HP, three phases at 400V, 15A magneto-thermal and 15A/300mA differential.
3Kw / 4 HP, three phases at 230V, 20A magneto-thermal and 20A/300mA differential.
2 can be used. In one of its ends, it is needed to connect a base normalised aerial
9
ENGLISH
2 up to 25 meters