Explanation Of General View - Makita UM164D Manual De Instrucciones

ENGLISH (Original Instructions)
1. Battery cartridge
2. Button
3. Lock-off button
4. Switch trigger
5. Indication lamp
6. Change lever
7. Protrusion on base frame
8. Base frame
9. Shear blades
10. Blade cover
11. Groove
12. Undercover
13. Locking lever
14. Press
15. Turn
16. Shear blade
SPECIFICATIONS
Effective cutting width
Stroke per minute (min
Dimensions (L x W x H)
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Symbols
The followings show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.................. Take particular care and attention.
....... Read instruction manual.
.................. Danger; be aware of thrown objects.
.................. Keep bystanders away.
.................. Cutting means continues to run after
the motor is switched off.

Explanation of general view

17. Crank
18. Basic alignment line on the tool
housing
19. Pins
20. Recessed part of crank
21. Apply grease
22. Base plate
23. Hole in the base plate of shear
blades
24. Oval holes that are overlapped
25. Groove in the undercover
26. Brush
27. Machine oil
28. Hedge shear blade
29. Hedge shear blade cover
30. Storage case
Model
-1
)
Net weight
.................. Do not expose to moisture.
END010-5
Ni-MH
Li-ion
31. Bent part of the base plate of
shear blades
32. Screws
33. Grass shear blade cover
34. Grass shear blade
35. Trimming direction
36. Tilt the blades
37. Hedge surface to be trimmed
38. String
39. Clamping nuts
40. Chip receiver
41. Screws on the shear blades
42. Blade cover to be always installed
before installing the chip receiver
43. Hook hole
UM164D
160 mm
1,250
292 mm x 178 mm x 130 mm
1.1 - 1.2 kg
D.C. 10.8 V
BL1013
DC10WA
............ Only for EU countries
Do not dispose of electric equipment or
battery pack together with household
waste material!
In observance of the European
Directives, on Waste Electric and
Electronic Equipment and Batteries
and Accumulators and Waste Batteries
and Accumulators and their
implementation in accordance with
national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be
collected separately and returned to an
9