JB Systems Light LC-1 Manual De Instrucciones página 4

ENGLISH
4. ROTATION BUTTON: Works only in one of the manual modes! Press this button
if you want the selected pattern to rotate. The rotation speed can be adapted with
the speed fader(8).
5. PATTERN SELECTOR: Works only in one of the manual modes! The fader is
used to choose one of the preprogrammed patterns of the connected laser.
6. MODE SELECTOR: There are 3 possible working modes that can be selected at
any time:
• AUTO (MUSIC) MODE: In this mode the connected laser works in full
automatic mode, as if the laser works in Master mode. However you can
change the speed of the automatic mode with the speed fader(8) and use
the blackout function(2). The other controls are not accessible. The music is
picked up by the internal microphone of the controller.
• MANUAL (MUSIC) MODE: In this mode the connected laser can be
controlled with the LC1. The speed of the movements depends on the music
picked up by the internal microphone of the controller.
• MANUAL (STATIC) MODE: In this mode the connected laser can be
controlled with the LC1. The speed of the movements only depends on the
speed fader. The internal microphone is shut off.
7. MOVE /RESET BUTTON: Works only in one of the manual modes!
• Stealth Laser connected: The Stealth Laser is not capable to move the
patterns around. This means that the "move" function is not available. However
when more than one Stealth laser is connected, you can reset all the units to
synchronize their movements. Press the Move/reset button for more than 2
seconds to reset the connected Stealth Lasers. While the reset takes place, all
the leds on the controller are off.
• Twinscan Laser connected: The selected pattern moves in horizontal and/or
vertical direction. The speed of the movements can be adapted with the speed
fader(8).
• Horizontal movement: press the button 1 time
selected pattern will be moved in horizontal direction.
• Vertical movement: press the button a second time
on. The selected pattern moves in vertical direction.
• Horizontal and vertical movements: press the button a third time
leds are lit. The selected pattern moves in both directions.
• No movements: press the button a fourth time
selected pattern stays at its current position.
8. SPEED FADER: In all modes, even in automatic mode, you can change the
speed of movements, conversions and rotation.
9. MUSIC INPUT SENSITIVITY: This trim potentiometer is used to adjust the music
input sensitivity. Normally you don't have to use it but in some cases you can use
a very small screwdriver to gently turn the trimmer until the connected laser
works in sync with the music. Only use this control if it is really necessary, the
trimmer is not made for frequent use!
10. LASER SWITCH: The LC-1 controller is capable of controlling the Stealth laser
OR the Twinscan Laser. With this switch you can choose which Laser you want to
use.
IMPORTANT: You can not use both models on the same controller at the
same time !!!
JB SYSTEMS 3/20 LC1 LASER CONTROLLER
OPERATION MANUAL
the left led turns on. The
the right led turns
both leds turn off. The
both