JB Systems Light LC-1 Manual De Instrucciones página 5

ENGLISH
11. OUTPUT XLR-CONNECTOR: This output connector is used to connect one or
more laser units, by means of a good quality balanced signal cable with XLR-♂
and XLR-♀ connectors like for example JB Systems signal cable "7-0063"
12. MICRO: The built-in microphone is used to synchronize the laser show to the
beat of the music.
13. MAINS INPUT: The power-cord connects the laser controller to the 220V AC
mains.
INSTALLATION
• Fix the laser units in a safe way and adjust to the suitable angle.
• Connect the inputs/outputs of the units, using a balanced signal cable.
• Connect the input of one unit to the Laser controller.
• Set the MASTER / SLAVE switch on all units to "SLAVE".
• Connect the units to the 220V AC mains, using the supplied power cords.
• Connect the Laser controller to the 220V AC mains.
• Put the key switches of all units in ON-position.
• The laser controller will act as master; it will control all the connected units.
SPECIFICATIONS
Power Supply:
Power Consumption:
Size:
Weight:
Fuse:
JB SYSTEMS
AC 230 V, 50Hz
5W
175 x 115 x 55mm
950g
250V ~ 100mA slow (ø 5x20mm)
4/20 LC1 LASER CONTROLLER
OPERATION MANUAL