Makita HM0860C Manual De Instrucciones página 5

Indicator lamp
1
2
The green power-ON indicator lamp lights up when the
tool is plugged. The indicator lamp is lit but the tool does
not start even if the tool is switched on, the carbon
brushes may be worn out, or the electric circuit or the
motor may be defective. If the indicator lamp does not
light up and the tool does not start, the ON/OFF switch or
the mains cord may be defective.
The red service indicator lamp lights up when the carbon
brushes are nearly worn out to indicate that the tool
needs servicing. After approx. 8 hours of use, the motor
will automatically be shut off.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Side grip (auxiliary handle)
1
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the side grip
by turning it counterclockwise, swing it to the desired
position and then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g;.). This chuck lubrication
assures smooth action and longer service life.
004482
1. Power-ON indi-
cator lamp
(green)
2. Service indica-
tor lamp (red)
004483
1. Side grip
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
2
1
Insert the bit into the tool. Turn the bit and push it in until
it engages.
1
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
Bit angle
5
003150
1. Bit shank
2. Bit grease
004484
1. Bit
2. Chuck cover
2
004485
004486