Medtronic MiniLink REAL-Time Guia Del Usuario página 6

conducted with several different cellular phones suggests that interference
will not be a problem if the phone is at least 12 inches (31 cm) from the
transmitter or receiving device while it is being used (greater separation
distance may be required for certain devices).
MiniLink charger
The MiniLink contains a non-replaceable, rechargeable battery that you can
recharge as needed with the charger. The charger has a green light that
shows the charging status and a red light that communicates any problems
during charging. If you see a red light, see the Troubleshooting section. The
charger needs a AAA or LR-03 battery to operate.
Installing a new charger battery (Blue Charger MMT-7705)
1 Remove the charger battery cap by turning it counter-clockwise 1/4 turn
using a coin in the groove of the cap.
2 Insert a new AAA or LR-03 battery with the flat
(-) end first. Make sure that you align the small
bumps on the battery cap with the small notches
in the charger's battery opening. Push in the cap
all the way using a coin. Turn the cap clockwise
1/4 turn to close.
Installing a new charger battery (Gray Charger MMT-7715)
1 Push the battery cover in and slide it off (as shown in the illustration).
2 Insert a new AAA or LR-03 battery. Make sure the (+/-) symbols on the
battery align with the symbols shown on the charger.
3 Slide the battery cover back on the charger.
Note: A new AAA or LR-03 battery contains enough power to recharge the
MiniLink more than 40 times. If the battery is installed incorrectly or is
- 4 -