Medtronic MiniLink REAL-Time Guia Del Usuario página 9

without removing them. No occlusive dressing is needed.
Disconnecting from sensor
1 Hold the MiniLink as shown, and pinch the
flexible side arms of the sensor between
your thumb and forefinger.
2 Gently pull the MiniLink away from the
sensor assembly.
MiniLink tester
The blue tester is used to test the MiniLink and to make sure it is
working.
Connecting the tester
1 Hold the MiniLink and the tester as
shown. Line up the flat side of the
tester with the flat side of the MiniLink.
2 Push the tester into the MiniLink until
the flexible side arms of the tester click
into the notches on both sides of the
MiniLink.
3 Within 20 seconds the green light on the MiniLink will flash for
about 10 seconds when properly connected.
4 Check the sensor icon on the monitor to ensure that the MiniLink
is sending a signal (see the monitor user guide).
Disconnecting the tester
1 Hold the MiniLink body as shown and
pinch the side arms of the tester.
2 With the tester arms pinched, gently pull
the MiniLink away from the tester.
Note: To save MiniLink battery life, do NOT
leave the tester connected after
testing.
Troubleshooting
Question: Why did the flashing green charger light turn off and a
- 7 -