ISO DDIN radio provision
1. Cut and remove the (2) plastic
shaded areas from the sub dash.
(Figures A, B).
2. Slide the radio housing into the
dash cavity and push in to engage
the clips to the sub dash.
(Figure C)
3. Attach the radio brackets to the
radio using the screws supplied
with the radio.
99-9013HG
Kit Assembly
Remove this
shaded area first
(Figure A)
Remove this shaded area
second. It is behind the first
piece that was removed.
(Figure B)
4. CAUTION!
The airbag light must be
plugged in before the ignition is
cycled on. Failure to do so will
cause an SRS (Airbag) fault that
can only be turned off by the
dealership.
Locate the factory wiring harness
in the dash and make all necessary
wire and antenna connections.
Metra recommends using the
proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation
Continued on next page
6
(Figure C)