Kit Assembly - Metra 99-9013HG Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Cut and remove the (2) plastic
shaded areas from the sub dash.
(Figures A, B)
2. Slide the radio housing into the dash
cavity and push in to engage the
clips to the sub dash. (Figure C)
3. Remove the metal "DIN" sleeve and
trim ring from the aftermarket radio.
4. Attach the radio brackets to the
radio using the screws supplied
with the radio. (Figure D)
99-9013HG

Kit Assembly

Remove this
shaded area first
(Figure A)
Remove this shaded area
second. It is behind the first
piece that was removed.
(Figure B)
5. Screw the pocket into the radio
and bracket assembly using
(4) #8 x 3/8" screws supplied with
the kit. (Figure D)
6. CAUTION!
The airbag light must be
plugged in before the ignition is
cycled on. Failure to do so will
cause an SRS (Airbag) fault that
can only be turned off by the
dealership.
Locate the factory wiring harness
in the dash and make all necessary
wire and antenna connections.
Metra recommends using the
proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation
Continued on next page
4
(Figure C)
(Figure D