Stopping The Engine - MADER KZ9500E Manual Del Usuario

such a selector) to the position suitable to equipment (Figure 32). If the generator is
not equipped with a voltage selector, there will be sockets of 110V and 220V
respectively, please plug the load wire in the relevant sockets suitable for the loads.
5.4.4 Turn on the AC breaker (Figure 33)
5.5 Instruction on DC Usage
Pay special attention to the connection of positive and negative poles in DC
application.
CAUTION The DC output should not be used as power supply for battery
charging.

6 Stopping the Engine

6.1 For Emergency: Set the ignition switch to OFF position directly to stop the
generator.
Fig 35
6.2 Under Normal Condition
6.2.1 Turn off the AC breaker and unplug all the loads (Figure 34)
16