Diesel Or Gasoline Motor Actuation - Nogueira EN-9F3B Manual De Instrucciones

Diesel or gasoline motor actuation

The metallic stand for assembling the diesel or
gasoline motor in the ensiling machine is
equipped with special rubber feet which do away
with the need for fastening the assembly to the
ground.
fig.25
MOTOR
fig.26
ASSEMBLY:
fig.27
1- Place the machine on the metallic stand, in the
place displayed in the above figure. Fasten the 4
feet to the stand rails.
16
MACHINE
Instruction manual
fig.28
2- Place the motor on the stand rails (as
displayed in the above figure).
3- Align the pulleys (machine / motor).
4- Fasten the motor to the rails using the screws,
washers and nuts.
fig.29
5- Install the pulley belts. Stretch them using the
existing stretcher on the stand.
PULLEY AND BELTS: Consult "TECHNICAL
CHARACTERISTICS" on this manual.
STRETCHER