Replacing Counter-Blades - Nogueira EN-9F3B Manual De Instrucciones

Replacing counter-blades

Worn counter-blades make the cutting of forage more difficult and exert more strain on the motor.
Whenever, you notice they are worn out, replace the counter-blade.
REPLACING THE COUNTER-BLADE
After the ensiling machine is turned off:
1- Remove springs C and D.
2- Hold strap E and lift the cover, bring the toothed roller towards the front, as shown in figure 54.
3- Remove the 2 fastening screws from the counter-blade.
4- Replace the counter-blade.
5- Put the toothed roller back to the operating position. Remember to connect the driveshaft again
which actuates the roller.
6- Replace springs C and D.
Important!
CORRECT
fig.53
When connecting the driveshaft, make sure the forks are aligned
(fig.55).
fig.55
SILAGE CHOPPERS
COUNTER-BLADE
WRONG
fig.54
fig.56
27