Removing The Collected Water - Telstar TDH030110MD Manual De Instrucciones

Protection Codes:
P2- Bucket is full or bucket is not in right position-Empty the bucket and replace it in the right position.(only
available for the uint with no pump feature.)
P2- Bucket is full -- Empty the bucket.(only available for the unit with pump feature.)
Note:
When one of the above malfunctions occurs,turn off the unit, and check for any obstructions.
Restart the unit, if the malfunction is still present, turn off the unit and unplug the power cord.
Contact the manufacturer or its service agents or a similar qualified person for service.

Removing the collected water

There are three ways to remove collected water:
1.Use the bucket
When the bucket is full, remover the bucket and empty it.
NOTE: If the pump hose drops when you remove the bucket , you must reinstall the pump hose properly to the
unit before replace the bucket into the unit.
Pump hose drops
water outlet
Reinstall pump hose properly
23
DEHUMIDIFIER
TDH030110MD