Telstar TDH030110MD Manual De Instrucciones página 24

2.Continuous draining
Water can be automatically emptied into a floor drain by attaching the unit with a water hose (Id≥Φ 5/16",not
included) with a female threaded end (ID:M=1" , not included). (NOTE: On some models, the female threaded
end is included)
Remove the plastic
cover by couter
clockwise rotation.
NOTE:
The pump operation on light blinks at 1Hz when the pump is operational failure. Please turn off the unit
and plug the power cord out. Check the following things: Cleaning the filter of the pump.
-Remove the bucket from the unit, take down the pump and clean the filter of the pump.
-Check that the pump drain hose does not link or block.
-Empty the water of the bucket.
-Reinstall the pump hose if it drops and reinstall the bucket properly. Turn on the unit. If the error repeats, call for
service.
NOTE:
Do not use this operation when the outdoor temperature is equal to or less than 0°C (32°F), otherwise
water is become ice that will cause the water hose blocked up and the unit failure. Make sure to empty the
bucket once a week when using the pump draining feature. When the pump draining feature is not being
used, remove the pump drain hose from the outlet. Press the pump drain hose outlet in and take the pump
drain hose out from it . Make sure do not let the water in the pump hose drip to the floor.
Extremo
Water hose
24
DEHUMIDIFIER
TDH030110MD