Nice For-Max A XM0900003 Instrucciones Y Advertencias Para La Instalación Y El Uso página 8

03. (Within the next 5 seconds) Press the same key as
1
2 before, on the OLD transmitter, for as many times
3
(Old) 2
as the number of the command you wish to
4
memorise:
1 Pressed once (•) = Step-Step command
2 Pressed twice (• •) = Up command
3 Pressed three times (• • •) = Down command
4 Pressed four times (• • • •) = Stop command
After approx. 3 seconds, the motor performs a
number of motions corresponding to the selected
command.
04. (Within the next 2 seconds) On the NEW transmit-
ter, press and hold the same key pressed above,
(New) 1( ) 2
and release as soon as the motor has completed
the first of the 3 LONG motions (= memorisation
complete).
Note – If the motor performs 6 LONG motions
means that the memory is full.
Note – In point 03 if the motor does not perform the same number of motions as
the number of the selected command, cancel the procedure by waiting for a few sec-
onds without pressing any other key. Then repeat the procedure from the start.
6.7 - Memorising a NEW transmitter, duplicating the commands of an
OLD transmitter
This enables memorisation of a NEW transmitter, duplicating the commands of an
OLD transmitter.
In this case it is essential to know in which Mode (I or II) the old transmitter was mem-
orised.
01. On the NEW transmitter, select any key (if memo-
rised in Mode I) or the required key (if memorised in
(New) (3")
Mode II) and press and hold for at least 3 sec-
onds. Then release the key.
02. On the OLD transmitter, select any key (if memo-
rised in Mode I) or the required key for transfer of
(Old) (3")
the function (if memorised in Mode II) and press
and hold for at least 3 seconds. Then release the
key.
6 – English
03. On the NEW transmitter, press the same key pres -
sed before in point 01 for at least 3 seconds and
(New) (3")
then release.
04. On the OLD transmitter, press the same key pres -
sed before in point 02 for at least 3 seconds and
(Old) (3")
then release.
05. The motor then completes 3 LONG motions (=
memorisation complete).
3
Note – If the motor performs 6 LONG motions it
means that the memory is full.