Start-Up; Before Each Use - AL-KO LSH 4 Traducción Del Manual Original De Instrucciones

GB
3. Stand log splitter on the base (05/b):
■
Insert both rear legs into the recesses in
cross-strut (05/6).
■
Push recess in pedestal (05/2) onto the
front leg (05/4).
NOTE
The longitudinal strut and cross-strut
may have to repositioned relative to one
another here.
4. Secure the connection of the two rear legs to
the cross-strut using a hexagon bolt (05/5).
5. Secure the recess of the pedestal to the front
leg using four hexagon bolts and nuts (05/3).
6. Secure the connection of the cross-strut to
the longitudinal strut using a hexagon bolt
(05/7).
■
Ensure that longitudinal strut and cross-
strut are not crooked and reposition relat-
ive to one another again, if necessary.

5 START-UP

WARNING!
Danger of injury from
faulty appliance
Operation of an faulty ap-
pliance can result in seri-
ous injury and damage to
the appliance.
■
Operate the appliance
only when it is undam-
aged and has not de-
fects, and when no
parts are missing or
loose.
34
5.1

Before each use

WARNING!
Risk of injury due to ap-
pliance instability
Tipping over of the appli-
ance can result in serious
injury and damage to the
appliance.
■
Fix the appliance se-
curely to the ground be-
fore starting work.
1. Carry out a visual inspection of the log split-
ter.
■
The log splitter must not be put into oper-
ation if parts of the appliance are miss-
ing, defective or loose.
2. Carry out a visual inspection of the mains
cable.
■
A defective mains cable (e.g. with cracks,
cuts, crushed or kinked points in the insu-
lation) must not be used.
3. Carry out a visual inspection for leaks in the
hydraulic system.
■
The log splitter must not be put into oper-
ation if the hydraulic system has leaks.
4. Use suitable means to fix the appliance se-
curely to the ground.
Start-up
LSH 4 | LSH 6