Publicidad
Fig. 5
Ac
Ac
5. Glue 10x40 Wood Dowels (C) in the two outer holes of the three-hole groups in the Left and
Right Glider Leg Assemblies (Qc & Rc). Attach the Glider Leg Supports (Sc) to the Left Glider
Leg Assembly (Qc) with Dowels (C) and 7x70mm Hex Screws (Ac). Attach the Right Glider
Leg Assembly (Rc) in the same way. The front and back leg supports will not touch the ground.
This is to allow for any uneven ground between the legs. See Figure 5.
6. NOTE: The Rocker Arms (I) are are slightly bent so the attachment holes on each end will be flush
against the glider and bench legs.
Insert a 6x50mm Hex Bolt (Ec) through a Washer (Fc) and the hole in the front lower corner of the
Left Leg Assembly (Lc), another Washer (Fc) and into a Rocker Arm (I). Attach a Hex Nut (Gc) and
tighten. Repeat for the right front leg and both back legs.
Repeat the above step to attach the top of the Rocker Arm (I) to the top holes in the arms of the
Left and Right Glider Leg Assemblies as shown in Figure 6.
BACK
Sc
C
C
Qc
Ac
C
C
FRONT
Sc
Arm of Left Glider
Leg Assembly
Gc
Ec
Fig. 6
Ac
Ac
Rc
Kc
Gc
Gc
F
Fc
Fc
Gc
I
961KFSIc – Page 5 – 10/08
Ec
Ec
Kc
Publicidad
