Publicidad
ASSEMBLY INSTRUCTIONS
Hex Wrench (provided), Phillips Screwdriver, Adjustable Wrench, Mallet or Padded Hammer, Outdoor Wood Glue
C
C
1. Spread a thin film of glue in the dowel holes in each end of the Back (Nc), Front Apron (Oc) and
Center Brace of Seat Assembly (Pc) and insert Dowels (C) as shown in Figure. 1. Gently tap with
a padded hammer and quickly wipe off any excess glue with a damp rag.
Nc
Fig. 2
Pc
Fig. 2a
2. NOTE: The seat must be attached so that the curvature of the Seat Assembly (Pc) matches
the curvature of the Center Brace of the Leg Assembly (Mc).
Spread a thin film of glue in the hole in the bottom of the Seat (Pc) and insert the dowel of the
Center Brace of Seat (Pc). Attach the Front Apron (Oc) to the Seat (Pc) the same way. See Figure 2a.
Spread a thin film of glue in the dowel holes of the Right Leg Assembly (Mc) as shown in Figure 2
and insert dowels of back/seat assembly. Wipe off excess glue with a damp rag. Using the
provided Hex Wrench (Kc), attach the Back Assembly (Nc), Seat Assembly (Pc) and Front Apron
(Oc) to the Right Leg Assembly (Mc) with 7x70mm Hex Screws (Ac). See Figure 2.
961KFSIc Somerset Glider 44"
TOOLS REQUIRED:
C
Nc
C
Oc
C
Pc
C
C
Fig. 1
C
Oc
Ac
Ac
Ac
Mc
NOTE: Center Brace
of Seat (Pc).
NOTE: Center Brace
of Seat (Pc).
C
Ac
Kc
NOTE: Center Brace
of Right Leg Assembly
(Mc).
961KFSIc – Page 3 – 10/08
Publicidad
