Changing The Battery - Elcometer SAGOLA 4600 XTREME Manual De Instrucciones

After take the key assembly (No.27) supplied with the gun and proceed to remove the valve seat
(No.23) with hook key. (See Fig.6)
For assembly, follow the reserve procedure. (see Fig.7)
• Packing gland of the air valve: Follow the above procedure to remove the valve seat. Them
with a 6 mm. Allen wrench, remove the packing gland (No.25) and extract the gasket (No.24) (see
Fig.8). Replace the packing gland and the washing support gasket (supplied in the specific kit)
(see Fig.9) and follow the reverse procedure.

12.2. Changing the battery

YOU SHOULD NOT REPLACE THE BATTERY IF THERE IS A POSSIBILITY
OF BEING IN AN EXPLOSIVE ATMOSPHERE.
The electric battery must be lithium mod. CR1/3N and 3v.
With a 7 mm Allen wrench, remove the pressure gauge housing plug (No.13) and locking seal
(No.11). Extract the dead battery and replace with a new one. Make sure the polarity is correct!!
Fig.04
Fig.06
Fig.08
ENGLISH
Fig.05
Fig.07
Fig.09