Elcometer SAGOLA 4600 XTREME Manual De Instrucciones página 43

42/43
The battery must not be replaced in hazardous areas.
See Atex regulations about explosion risk areas.
The battery housing and the pressure measurements sight glass must not be opened in a loca-
tion where there is any danger of explosion. (UNE EN 60079-11:2013 standard. Do not change
batteries in a dangerous location Ex).
Always use approved breathing units in accordance with current Standards and Re-
gulations in order to protect yourself from emissions produced during application.
Never exceed the maximum air inlet pressure (8 bar). Excessive pressure will cause greater en-
vironmental contamination. To provide the hose with compressed air for the pistol, fit a pressure
regulator and a safety valve.
As a general, preventive measure we advise you to wear goggles in accordance with
the specific environmental regulations and characteristics for the work centre.
Wear gloves when handling the product (see the manufacturer's recommendations)
and clean the gun.
If, when the gun is in use, the ambient noise level exceeds 85 dB (A) the use of appro-
ved ear protectors is required.
The gun in itself does not propitiate any mechanical risk of perforations, impact or pinching,
except those deriving from incorrect installations and handling.
While work is in progress, no vibrations are transmitted from the gun to any part of the body of
the operator and reaction forces are minimal.
USE SAGOLA ANTISTATIC HOSES TO ELIMINATE POSSIBLE ELECTRICAL
DISCHARGES THAT MIGHT CREATE THE RISK OF FIRE OR EXPLOSION.
Pay adequate attention when handling the gun in order to prevent any damage that might lead
to dangerous situations for the user or personnel standing near the unit, as a consequence of
leaks, breakages, etc. Do not use it if your mental capacity, perceptions and reactions are altered
due to substances such as alcohol, drugs, medicines, etc., or by tiredness or for any other reason.
The gun has been designed for use at ambient temperature. Its maximum service temperature
is 60°C. Although the air temperature of the compressed air or product is higher, this must not
exceed the maximum average temperature in the body of the gun. If the temperature exceeds
43°C, it is necessary to use personal protective equipment, such as gloves to thermally insulate
your hands from the unit.
The use of solvents and/or detergents that contain halogenated hydro-
carbons (trichloroethane, methyl chloride, etc.), may cause chemical
reactions in the unit as well as in its zinc-coated components (trichloroe-
thane mixed with small amounts of water produces hydrochloric acid).
For this reason, these components may rust and in extreme cases the
chemical reaction caused may be explosive. We recommend you to use
products that do not contain the aforementioned components. Do not
use acids, soda (alkalis or pickling substances, etc.) for cleaning under
any circumstances.
In general, tprecautions must be taken whenever the gun is handled, in order to prevent any
damage to this.
ENGLISH