Ariston SENSYS 3318585 Instrucciones Para La Instalación Y El Uso página 120

table of error codes
GB
ERROR DESCRIPTION
9 11 TE sensor error
4-way valve error.Service reset to
9 12
remove fault
9 13 LWT error
9 14 TR sensor error
9 15 TDM Communication error
9 16 TEO sensor error
Freeze error, LWT and/or TR too low.
9 17
Service reset to remove fault
9 18 Pump Down Error
9 19 HIGH SDT Error
9 20 HC Probes Error
9 21 Error Electricity/Gas Cost ratio
9 22 Freeze Error
9 23 Heating Circuit pressure Error
9 24 Communication error
9 25 Boiler not present
9 30 EM NO Circulation Error
9 31 INVERTER Error
9 33 Overheat
9 34 DHW Tank sensor damaged
9 35 Tank overtemperature
9 36 Floor Thermostat 1 error
9 37 No circulation error
9 38 Anode Fault
9 39 HP error
9 40 Hydraulic scheme not defi ned
9 41 Night tariff contact not defi ned
9 42 Load shedding contact not defi ned
9 44 Cooling overtemperature
9 45 Flow switch stuck
9 46 HP compressor error
9 47 4-way valve error
9 48 TD sensor error
9 49 TS sensor error
TD overtemperature.Service reset to
9 50
remove fault
9 51 TD overtemperature error
120
ERROR DESCRIPTION
9 52 TO sensor error
9 53 Compressor heater mismatch error
9 54 Base panel heater mismatch error
9 55 Water Flow Check Error
9 57 HP Fan model mismatch
Restoring operation
If the system shuts down, a code will
appear on the system interface display
signalling the type of shutdown and the
reason behind it.
To restore normal operation, follow the
instructions provided on the display or, if
the error persists, contact an authorised
Technical Service Centre for assistance.
(*) BUS power supply overload
A BUS power supply overload error may
occur due to the connection of three or
more devices within the installed sys-
tem. Devices which may overload the
BUS network include:
- Multizone module
- Solar pump assembly
- Module for instant production of do-
mestic hot water
To avoid overloading the BUS power
supply, set microswitch 1 on one of the
P.C.B.s inside the equipment connected
to the system (except the boiler) to OFF,
as illustrated in the fi gure.
1
microswitch
ON
OFF
2