Ariston SENSYS 3318585 Instrucciones Para La Instalación Y El Uso página 65

product description
(AP) Access Point confi guration
- ( ) Gateway connected to internet
- ( ) Gateway not connected to router
- ( ) Gateway connected to router
but not to the internet
- ( ) Software update in progress
Visible symbols with solar heating
system and/or heat pump installed:
- ( ) Boiler
- ( ) Boiler operating
- ( ) Under-fl oor heating system
- ( ) Single-coil indirect cylinder
- ( ) Double-coil indirect cylinder
- ( ) Solar-electric indirect cylinder
- ( ) Solar collector
- ( ) Circulation pump
- ( ) Heat exchanger
- ( ) Diverter valve
- ( S1) Collector sensor
- ( S2) Low indirect cylinder sensor
- ( S3) High indirect cylinder sensor
- ( S4) Under-fl oor heating system
thermostat
- ( ) Indirect cylinder overheating
- ( ) Collector overheating
- ( ) Anti-frost function
- ( ) Thermal Cleanse Function
- ( ) Recooling function
- ( ) Digital display format
- ( ) Analogue display format
- ( ) Confi gurable device
- ( ) Heat pump
- ( ) Heating element 1
- ( ) Heating element 2
- ( ) Heating element 3
- ( ) Heating element excluded
- ( ) Sanitary comfort in the period
reduced fare
- ( ) Sanitary comfort in the period
reduced fare and a setpoint
reduced to 40 ° C during the
period at full fee
- ( ) BOOST mode
- ( ) Silent mode
- ( ) Special functions
- ( ) Hybrid mode operation
Initial start-up
The fi rst time the SENSYS system inter-
face is connected, the user is required to
choose certain basic settings.
First, you will need to select the user in-
terface language.
Turn the knob and select the desired
language, then press the OK button to
confi rm. Move on to setting the date and
time. Turn the knob to make a selection,
press the OK button to confi rm your se-
lection, turn the knob to set the value.
Press the OK button to confi rm.
Save the settings by pressing OK.
Press the OK button to access the Menu.
Use the knob in the centre to scroll
through the menu list and select a pa-
rameter, then press OK to confi rm.
CAUTION
Some parameters are protected with an
access code (safety code) which protects
the boiler settings from unauthorised
use.
GB
65