Publicidad
Idiomas disponibles
Idiomas disponibles
1. ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Take the unit out of its box and make
sure that all of the pieces are there
Fig.1: (1) Main body; (36) Handlebar
stem; (5) Stabiliser bar with wheels;
(2) Stabiliser bar with adjustable
blocks; (34) Monitor; (31), (33), (38),
(3) and (6) Covers; (28) Saddle; (26)
Left pedal; (18) Right pedal; (19)
Saddle height adjustment knob; (71)
Transformer, (59) Main post.
Bag of screws containing: (40) Screw
M8x55; (50) Screw M4x20; (48) Screw
M4x15; (41) Flatwashers M8; (52)
Flatwashers
M4;
spanner; Box spanner with screwdriver.
2. FITTING THE STABILISER
BARS.-
Take the rear stabiliser bar (2) and
position it on the machine's rear stand
bracket, as shown in Fig.2, inserts
bolts (40), fit the washers (41) and
tighten securely.
Take the front stabiliser bar with
wheels (5) and position it as shown in
Fig.2, insert bolts (40), fit the curved
washers (41) and tighten securely.
3. ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the
letter, fitting these incorrectly could
damage the screw thread on the
pedal or the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal, marked with the
letter (R), screws onto the right-hand
crank, also marked with an (R), in a
clockwise direction. Tighten securely,
Fig.3.
Double
ended
The left-hand pedal, marked with the
letter (L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely Fig.3.
4. INSTRUCTIONS FOR
FITTING THE SADDLE.-
Next, take the horizontal tube for the
saddle (23) and attach the saddle (28)
to it, Fig.4, tighten the nuts (46).
VERTICAL ADJUSTMENT.
In order to raise or lower the saddle
post (23), first loosen off the control
knob (19) on the saddle post a little by
turning it in an anticlockwise direction,
pull the control knob back and without
releasing it, move the saddle post up
or down, Fig.4. When it is at the right
height release the knob and it will lock
into a hole on the saddle post. Tighten
it up by turning the control knob (19) in
a clockwise direction.
HORIZONTAL ADJUSTMENT.
To adjust the saddle's horizontal
position, loosen the control knob (24)
on the saddle's horizontal bar and
move the saddle, along with the bar,
into the desired position, then tighten
the control knob securely, Fig.4.
5.- FITTING THE BOTTOM
POST COVER.-
Take the main post (59) and insert the
bottom post cover (38) in the direction
of the arrow, Fig.5.
6.- FITTING THE MAIN POST.-
Take the screws (57) out of the main
body (1), bring the main post (59) up
to the boss on the main body, and
connect terminals (61-62).
9
direction.
Tighten
Publicidad
