Lubrication; Lubrication Schedule - Husqvarna P-ZT 60 Manual Del Operador

LUBRICATION

Lubrication Schedule

12/12 Every year
1/52 Every Week
1/365 Every day
General
Remove the ignition key to prevent unintentional
movements during lubrication.
When lubricating with an oil can, it must be
filled with engine oil. When lubricating with
grease, unless otherwise stated, use high grade
molybdenum disulphide grease.
For daily use, the machine should be lubricated
twice weekly. Wipe away excess grease after
lubrication.
It is important to avoid getting lubricant on the
belts or the drive surfaces on the belt pulleys.
Should this happen, attempt to clean them with
spirits. If the belt continues to slip after cleaning,
it must be replaced. Gasoline or other petroleum
products must not be used to clean belts.
28
Lubricate with grease gun
Filter change
Oil change
Level check
*
Change hydraulic drive filters.
p Change engine oil every 50 hours.
WARNING! Escaping hydraulic oil
under pressure can have sufficient force to
penetrate the skin, causing serious injury. If
injured by escaping fluid, see a doctor at once.
Serious infection or reaction can develop if
proper medical treatment is not administered
immediately.