How To Assemble The Light Kit - Fanimation The Crestford FP7954OB El Manual Del Propietario

1. Insert light bulbs into sockets. (Figure 24)
2. Remove finial, trim cover, nut, flat washer and rubber
washer from post on light kit assembly. (Figure 25)
3. Thread the fan pull chain through the hole in the side
of glass and let light pull chain into the center hole of
glass. Lift the glass up and position it onto the
adapter-switch housing. Secure with rubber washer,
flat washer and nut. Thread the fan pull chain through
the hole in the side of trim cover and let light pull chain
into the center hole of trim cover. Align the holes in the
trim cover and glass, then thread the light pull chain
through the finial and screw the finial onto the threaded
rod end until tight (Do not overtighten). (Figure 26)
4. Install the fan chain coupler and light kit chain coupler.
(Figure 27)

How to Assemble the Light Kit

Trim Cover
10
Light bulb
Figure 24
Light Kit
Assembly
Figure 25
Adapter-Switch
Housing
Glass
Rubber Washer
Flat Washer
Nut
Finial
Figure 26
Figure 27