How To Assemble The Light Kit - Fanimation The Embrace 44 Manual Del Propietário

How to Assemble the Ceiling Fan Blades (continued)
2. Secure the blade holders to the bottom of the motor
assembly using the 1/4 -20 x 14 mm screws. (Figure 2)
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Slightly
loosen the remaining two screws. Assemble the light
plate assembly to the support bracket using the two
key slots in the light plate. Replace the third screw
and securely tighten all three screws. (Figure 1)
2. Remove one of the three screws in the light plate
assembly. Slightly loosen the remaining two screws.
(Figure 2)
3. Connect the 2 single-pin connectors from the socket
plate assembly to the 2 single-pin connectors from motor
assembly. (Figure 3)

How to Assemble the Light Kit

Screws
(2 per assembly)
HARDWARE USED:
SCREWS
Motor
Assembly
Light Plate Assembly
Light Plate
Assembly
Motor
Assembly
Socket Plate
Assembly
10
Motor
Blade Holder
Assembly
Figure 2
x 6
Screws (3)
Figure 1
Figure 2
Figure 3