Publicidad
Idiomas disponibles
Idiomas disponibles
3
FITTING WITH SPRAY
• Feed SPRAY HOSE (1) through SPRAY HOLDER (2)
and attach COUPLING NUT (3) of HOSE (1) to
HOSE ADAPTOR (4).
4
CONNECT SPRAY HOSE & INSTALL WEIGHTS
• Remove AERATOR. With handles in OFF
position, turn on water supplies and check
all connections for leaks.
• Operate both HANDLES to flush water lines
thoroughly. Rotate SPOUT in both directions.
Replace AERATOR.
• Direct SPRAY HEAD into sink and activate
SPRAY. Check HOSE connections for leaks.
5
SERVICE
If faucet drips proceed as follows:
• Turn VALVE in OFF position.
• If faucet drips, operate handle several times from
"off" to "on". Do not apply excessive force.
• Clogged CARTRIDGE inlets may cause reduced
flow in "full on" hot or cold. To clean inlets,
first turn off water supply, then:
• Remove HANDLE (1), CAP (2), MOUNTING
SCREWS (5), ADAPTER (6), and CARTRIDGE (3).
Clean inlets and MANIFOLD (4). Reassemble
CARTRIDGE (3), alternately tightening screws.
Replace CAP and HANDLE. Check flow.
AERATOR
- 2 -
4
3
1
2
5
6
3
4
M965768 Rev. 1.1 (8/20)
1
2
Publicidad
