Safety Information - Zoeller 2701 Manual De Instrucciones

Ocultar thumbs Ver también para 2701:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate, or install the product.
NOTE: Pumps with the "UL" mark and pumps with the "US" mark are tested to UL Standard UL778. CSA
certified pumps are certified to CSA Standard C22.2 No. 108. (CUS.)
DANGER
FIRE/EXPLOSION HAZARD.
Do not pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do not use in a
flammable and/or explosive atmosphere. Failure to follow these warnings could result in death or serious
injury and/or property damage.
ELECTRICAL SHOCK HAZARD.
Always disconnect power source before performing any work on or near the motor or its connected load.
If the power disconnect point is out-of-sight, lock it in the open position and tag it to prevent unexpected
application of power. Failure to do so could result in fatal electrical shock.
ELECTRICAL SHOCK HAZARD.
Do not handle the pump with wet hands or when standing in water, as fatal electrical shock could occur.
Disconnect main power before handling unit for ANY REASON!
RISK OF ELECTRIC SHOCK.
These pumps have not been investigated for use in swimming pool areas.
WARNING
ELECTRICAL SHOCK ALERT.
To reduce the risk of electric shock, install only a circuit protected by a ground-fault circuit-interruptor (GFCI).
Make certain that the ground fault receptacle is within the reach of the pump's power supply cord. DO NOT
USE AN EXTENSION CORD.
ELECTRICAL SHOCK ALERT.
Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
ELECTRICAL SHOCK ALERT.
Do not kink power cable, and never allow the cable to come in contact with oil, grease, hot surfaces,
chemicals, or sharp objects. Replace damaged or worn wiring cord immediately.
ELECTRICAL SHOCK ALERT.
As a safety measure, each electrical outlet should be checked for ground using an Underwriters Laboratory
Listed circuit analyzer, which will indicate if the power, neutral, and ground wires are correctly connected to
your outlet. If they are not, contact a licensed electrician.
ELECTRICAL SHOCK ALERT.
These pumps are supplied with a 3-prong grounded plug to help protect you against the possibility of
electrical shock. DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE GROUND PIN.
ELECTRICAL SHOCK ALERT.
To reduce the risk of electric shock, install only a circuit protected by a ground-fault circuit-interruptor (GFCI).
ELECTRICAL SHOCK ALERT.
Make sure the pump electrical supply circuit is equipped with fuses or circuit breakers of proper capacity. A
separate branch circuit is recommended, sized according the National Electrical Code for the current shown
on the pump name plate.
CHEMICAL ALERT.
Prop65 Warning for California residents:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
2

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido