Progress Lighting P2663 Instrucciones De Instalación

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
NOTE: The Remote System is equipped with learning frequency function which has 65K
code combinations to prevent potential interference from other remote units. The frequency
on your Receiver and Transmitter units have been preset at the factory. We recommend
setting up frequency while installing ceiling fan instead of using initial frequency set by
factory. The operation of changing frequency is as below. When Receiver AC power is ON,
the first press will be Transmitter FAN OFF(Stop) within 60 seconds. In addition, holding this
button FAN OFF (Stop) over 5 seconds,
frequency which is the same as transmitter that has been set up. After completion of above
operation, you can operate the ceiling fan and light.
If set up couldn't be proceeded successfully, please turn off power of the receiver and then
repeat the above action.
Install the CR2032, 3V battery (included). Remove the battery if not used for long periods
of time to prevent damage to the hand held remote. (Fig. 1)
Safety Precautions:
WARNING: Disconnect source of electrical power by removing the fuse or switching
off circuit breakers.
• Do not use with solid state fans.
• Electrical wiring must meet all local and national electrical code requirements.
• Electrical source and fan must be 115/120 volts, 60 hz. Maximum fan motor amps 1.5
Maximum light watts 300-incandescent, 300VA (Electronic ballast, LED)
1. RECEIVER INSTALLATION
NOTE: Before the electrical power is disabled for the installation of the receiver and wall
control; the light kit must be left in the on position and the ceiling fan on the highest speed.
Step 1. Insert Receiver into Hanger Bracket with the flat side of the Receiver facing the
ceiling.
Step 2. Motor to Receiver Electrical Connections: Connect the WHITE wire from the fan to
the WHITE wire marked "TO MOTOR N" from the Receiver. Connect the BLACK wire from
the fan to the BLACK wire marked "TO MOTOR L" from the Receiver. Connect the BLUE
wire from the fan to the BLUE wire marked "For Light" from the Receiver. (Fig. 2)
Step 3. Receiver to House Supply Wires Electrical Connections: Connect the WHITE wire
(Neutral) from the outlet box to the WHITE wire marked "AC in N" from the receiver. Connect
the BLACK wire (Hot) from the outlet box to the BLACK wire marked "AC in L" from the
receiver. Secure all wire connections with the plastic wire nuts provided. (Fig. 2)
After all splices are made, check to make sure there are no loose strands. As an additional
precaution we suggest to secure the plastic wire connectors to the wires with the electrical
tape.
2. OPERATING THE HAND HELD REMOTE CONTROL
1. Light Button:
Press and release the button to turn the light ON or OFF. Press and hold the button to set the
desired light brightness. The light will cycle between bright and dim settings as long as the button
is pressed. The light key has an automatic auto-resume feature that allows the light to remain at
the same brightness as the last time it was turned off.
2. Speed Buttons
Press and release the button for the desired speed.
3. Stop Button
This button stops the fan.
4. Timer Button
2Hour, 4Hour, 8Hour timer
turns off the fan
NOTICE!
Your ceiling fan and light kit assembly must meet the following requirements:
Do Not install this remote with wall solid state speed control or wall light dimmer control.
It will permanently damage the receiver of remote control and cause the fan function failure.
CAUTION:
Ceiling Angle shall Not Exceed 30 Degrees, For Mounting controller. Models UC-7067RC, UC7067RY
the light kit will flash twice, the receiver will learn
Battery
CR2032
LIGHT
Function option
ON/OFF or DIM
Fig.1
Fig.2
High speed
Medium speed
Low speed
Stop
Light
Timer