Tabla de contenido
Publicidad
SECTION V
A.
Assembly of machine from case
1. Remove Tube Lathe, Drive Motor and Bench Plate
from storage case.
2. Install two FHCS through Bench Plate into Pinion
Housing using supplied Allen Wrench.
3. Install Drive Motor into the Pinion Housing and ten-
sion Clamp Bolt with Allen Wrench.
4. The Bench Plate can be removed for field or in-
place use.
B.
Clamp Shoe selection and installation
1. Select Shoe Set by referring to selection chart on
page 22.
2. Place the Shoe Set into the back side of the ma-
chine with the size marks facing towards the motor
(Figure 1).
3. Tension the two Thumb Screws on the lower half of
the machine.
4. Rotate the clamping handle clockwise until con-
tacts the upper shoe.
5. Slide the Retaining Pin into the hole on the back of
the upper shoe.
6. Rotate Clamping Handle counterclockwise to open
clamping shoes.
TUBE LATHE
SET-UP AND OPERATION (cont.)
C.
D.
FIGURE 1
E.
Workpiece Clamping
1. Open Clamp Shoes by rotating Clamping Handle.
2. Place workpiece into machine.
3. Rotate Clamping Handle clockwise to tension
workpiece.
Splitting Frame Halves (for field or in-place use)
1. Loosen four bolts on rotating and stationary frames
2. Separate frame halves.
3. Position frame halves around workpiece (Figure 2).
4. Tension four bolts on rotating and stationary frames.
Tool Slide operation
1. Use supplied Allen Wrench on top of Starwheel and
rotate clockwise to fully retract Tool Slide.
2. Rotate Starwheel counterclockwise slightly to re-
move Feed Screw backlash.
3. Align Starwheel's point to line on sticker as shown
(Figure 3).
4. After completion of cutting operation, repeat steps
1 to 3.
FIGURE 2
13
Publicidad
Tabla de contenido
