Section Ii Safety Instructions - Wachs TL 2.0 Manual De Instrucciones

SECTION II
The E. H. Wachs Company takes great pride in manu-
facturing safe, quality products with user safety a
priority.
The E.H. Wachs Company recommends that all users
comply with the following safety rules and instructions
when operating our equipment.
Read the Following thoroughly
before proceeding.
Keep clear of rotating parts during opera-
tion. Hands and arms should be kept a
minimum of 2' away from moving parts
exept during starting and stopping.
1 . READ THE OPERATING MANUAL!! Reading the setup and
operating instructions prior to beginning the setup procedures
can save valuable time and help prevent injury to operators or
damage to machines.
2 . INSPECT MACHINE & ACCESSORIES! Prior to machine
setup physically inspect the machine and it's accessories. Look
for worn tool slides, loose bolts or nuts, lubricant leakage,
excessive rust, etc. A properly maintained machine can greatly
decrease the chances for injury.
3 . ALWAYS READ PLACARDS & LABELS! All placards, la-
bels and stickers must be clearly legible and in good condition.
Replacement labels can be purchased from the manufacturer.
4 . KEEP CLEAR OF ROTATING PARTS! Keep hands, arms
and fingers clear of all rotating or moving parts. Always turn
machine off before attempting any adjustments requiring contact
with the machine or it's accessories.
5. SECURE LOOSE CLOTHING & JEWELRY! Loose fitting cloth-
ing, jewelry; long, unbound hair can get caught in the rotating
parts on machines. By keeping these things secure or removing
them you can greatly reduce the chance for injury.
6 . KEEP WORK AREA CLEAR! Be sure to keep the work area
free of clutter and nonessential materials. Only allow those
personnel directly associated with the work being performed to
have access to the area if possible.
6
TUBE LATHE
SAFETY INSTRUCTIONS
CAUTION
For your safety and the safety of others, read and
understand these safety recommendations and op-
erating instructions before operating.
ALWAYS WEAR PROTECTIVE EQUIPMENT:
Impact resistant eye protection
must be worn while operating or
working near this tool.
For additional information on eye and face protection, refer
to federal OSHA regulations, 29 Code of Federal Regula-
tions, Section 1910.133., Eye and Face Protection and
American National Standards Institute, ANSI Z87.1, Oc-
cupational and Educational Eye and Face Protection. Z87.1
is available from the American National Standards Institute,
Inc., 1430 Broadway, New York, NY 10018.
CAUTION
Personal hearing protection is rec-
ommended when operating or
working near this tool.
Hearing protectors are required in high noise areas, 85
dBA or greater. The operation of other tools and equipment
in the area, reflective surfaces, process noises and reso-
nant structures can substantially contribute to and increase
the noise level in the area. For additional information on
hearing protection, refer to federal OSHA regulations, 29
Code of Federal Regulations, Section 1910.95, Occupa-
tional Noise Exposure and ANSI S12.6 Hearing Protectors.
Some individuals are susceptible
to disorders of the hands and arms
when exposed to tasks which in-
volve highly repetitive motions
and/or vibration. Disorders such as Carpal tunnel
syndrome and tendonitis can be caused or aggra-
vated by repetitious, forceful exertions of the hands
and arms.
• Use minimum hand grip force.
• Keep wrists straight.
• Avoid prolonged, continuous vibration exposure.
• Avoid repeated bending of wrists and hands.
• Keep hands and arms warm and dry.
Gloves are not a form of protec-
tion and should not be worn
while operating machiner y.
Chips and debris which are
generated during operation should be disposed of
in a safe manner. This should be done with the use
of a dust pan and broom to avoid exposure to hands.
WARNING
CAUTION
CAUTION