Tool Bit Installation; Machining Instructions - Wachs TL 2.0 Manual De Instrucciones

SECTION V
F.

Tool Bit Installation

1. Follow steps 1-3 in section "E" to bring Tool Slide to
its uppermost position.
2. Loosen center bolt on Tool Slide Cover Plate.
3. Slide Tool Bit in from top and position cutting edge
approximately 1/16" off of workpiece O.D.
4. Tension center bolt on Tool Slide Cover Plate (Fig-
ure 4).
G.

Machining Instructions

CAUTION: Beware of falling pipe
when cutting long lengths.
1. Begin cutting operation by squeezing motor trigger.
Set speed controller by using the chart on page 17.
14
TUBE LATHE
SET-UP AND OPERATION (cont.)
FIGURE 3
FIGURE 4
2. Slide Trip Handle inward to engage Starwheel Feed
System on the Tool Slide. To pause cutting opration,
pull Trip Handle outward (Figure 5).
CAUTION: Do not let tool
slide travel past warning
arrow.
3. At completion of cut, release motor trigger to stop
machine rotation.
FIGURE 5