HIKVISION DS-PD2-P15E Manual Del Usuario

DS-PD2-P15E
15m Digital PIR Detector
EN50131-2-2:2008 Security Grade (SG) 2
EN50131-1:2006+A1:2009 Environmental Class (EC) II
Diagram References
1
A D G
Printed Circuit Board (PCB) Lens Collet Casing Screw
B E
PCB Screw
LED Light Pipe
C F
Lens Nut
2
3 3
O
3 4
EOL Resistor Headers: TheDS-PD2-P15E has 2 sets of header pins (as shown). These
headers are used to select the End of Line resistance for EOL wiring applic a
NOTE: If EOL wiring is not used, leave the headers OFF.
3 5
Remote LED Enable: This is used when the LED is disabled via the LED ON/OFF
link. To enable this feature the LED terminal needs to be connected to an output
on the control panel. When the system is in walk test mode the output should
be at 0v. For Pyronix panels the output would usually be programmed as
'Remote LED enable'.
3 6
A
N/C - Normally Closed Wiring
(EXAMPLE ONLY, SEE CONTROL PANEL INSTRUCTIONS)
B
DEOL Wiring
(EXAMPLE ONLY, SEE CONTROL PANEL INSTRUCTIONS)
C
Generic Control Panel (shows resistor loc
3 7
Powering Up:
is ready to use.
3 9
3 8
The 15m Volumetric Lens. Dimensions and Weight
Op cal and Range Features
Volumetric Coverage 85 , 60 zones, and 7 planes
Maximum Range 15 m
Op mal 1.8 - 2.4m
Creep- Yes
Key Features
Blue Wave Technology Yes
Automa c Yes
Digital Yes
DEOL Resistors on Board Yes
Tamper Front
Electrical
Power Supply 9-16 V DC normal, 12 V DC typical
Current 11mA
Current 13mA
Relay Type Solid state
Outputs Relay 50mA 60 VDC, 42 VAC (RMS)
Tamper Terminal 12 VDC 50mA
Alarm Response 2.5 seconds
Detec on Speed 0.3 - 3m/s
Op cs Sealed
3D
Geometric
Other Details
Opera ng Temperature
-10 °C to 40 °C
Weight 125g without bracket
Dimensions(H x W x D) 117 × 69 × 50 m m
Accessories
Ceiling Bracket Included Yes
Wall Bracket Included Yes
COPYRIGHT ©2018 Hangzhou Hikvision Digital Technology Co., Ltd.
User Manual
ALL RIGHTS RESERVED.
COPYRIGHT ©2018 Hangzhou Hikvision Digital Technology Co., Ltd.
ALL RIGHTS RESERVED.
or implied, regarding to the Manual.
About this Manual This manual is applicable to video security control panel.
About this Manual
This manual is applicable to detector.
Please use this user manual under the guidance of professionals.
Trademarks Acknowledgement
latest version in the company website
Please use this user manual under the guidance of professionals.
Trademarks Acknowledgement
owners.
This product and - if applicable - the supplied accessories too are marked with "CE" and
comply therefore with the applicable harmonized European standards listed under the
1
START
C D
s.
3
A
B
D
Hangzhou Hikvision Digital Technology CO.,Ltd.
2 PCB
A
B B
LED ON LED OFF
E
f) Back
Tamper
F G
C
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
TAMPER
DEFAULT
PREDEFINITO
= =
LOW AUTO AUTO HI
=
LOW AUTO AUTO HI
®
=
AUTO HI
LOW AUTO
C3
B
A
ALARM
6K8, 5K6,
4K7, 2K2, 1K
TAMPER
5K6, 4K7, 2K2, 1K
PIR
AUTO
+ +
+ +
HIGH / LOW
HIGH
+
+
+ +
The K
The KX
D LOW
+ +
+ +
3
EOL
C