XDH10TT-WE
10m Two Way Wireless External DT Detector
EN50131-5-3:2005+A1:2008
Environmental Class IV
E N G L I S H
(Diagram references)
1
PCB Overview
2
LED Indications
3 3
Microwave Adjustment: 0m to 15m
3 4
Dip Switches 1-4
3 5
Learning Procedure
3 6
Signal Strength Test
3 7
Battery Level Test
3 8
Inserting the Fixed Mask or Flexible Mask
3 9
Flexible Mask Adjustment (1)
3 10
Flexible Mask Adjustment (2)
3 11
10m Lens Diagram
3 12
XD WALLBRACKET & XD 45D ADAPTOR
3 13
XD WALLBRACKET
3 14
XD FIXEDBRACKET
3 15
XD10TT-WE Guidelines
Technical Specification
Transmission Frequency: 868MHz, FM Transceiver Narrow Band
Transmission Method and Range: Fully encrypted rolling
Input Con guration: Type: Normally Closed.
Lens/Detection: 2 x Lens 5 (UV Compensated)
Detection Speed: 0.2- 2.5m/s
Tri-Detection Method: 2 low noise dual element passive infrared sensors
and a microwave doppler unit
Indication: LEDs (Signal, Battery, Alarm, Tamper)
Mounting Height & Range: 1.8M - 2.4M = 10M (Lens 5)
Pet Immunity: 10kg
Tamper Switch: Both front and rear and external tamper input
Storage Temperature: -40°C to +80°C (+40°F to 176°F)
Operating Temperature: -30°C to +70°C (+22°F to 158°F)
Dimensions & Weight: 180mm x 80mm x105mm x 0.5kg
Emissions EN55022 Class 2.
IP Rating: IP55
Colour and Casing: White. 3mm ABS
Batteries: 2x 3V 4700mAh, Lithium battery packs (BATT-ES1)
Life: Up to 3 Years
NOTE: BOTH BATTERIES MUST BE REPLACED WHEN BATTERY LOW IS PRESENT.
Compatible with the Enforcer, PCX and UR2-WE
Battery Information
The batteries supplied have been chosen to provide long service life whilst,
for safety reasons, having limited output current.
The battery leads must be connected for operation. When disposing of the
product, the battery must be removed and disposed of separately in
accordance with the local regulations.
Product Information
For electrical products sold within the European Community. At the end of the electrical
products life, it should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice in your
country.
To prevent possible damage to components, any static charge on your body needs to be
eliminated before touching the inside of the unit. This can be accomplished by touching
some grounded/earthed metallic conductor such as a radiator/pipework immediately
before replacing the batteries.
Warranty
This product is sold subject to our standard warranty conditions and is warranted against
defects in workmanship for a period of two years (batteries excluded). In the interest of
continuing care and design, Pyronix Ltd reserves the right to amend specifications,
without giving prior notice. Please see the control panels programming manuals for
further information.
0845 6434 999 (UK). +44(0)1709 535 225
START
1
2 x 3.0V
Lithium
4700mAh
TAMPER
3
4
English
LEDs ON
LEDs OFF
Buzzer OFF
Buzzer ON
Top PIR
Top PIR
LOW
HIGH
Bottom PIR
Bottom PIR
12 13
LOW
HIGH
4
Italiano
LEDs OFF
LEDs ON
Buzzer OFF
Buzzer ON
Sensitivita' PIR
Sensitivita' PIR
Superiore: Bassa
Superiore: Alta
Sensitivita' PIR
Sensitivita' PIR
Inferiore: Bassa
Inferiore Alta
3 4
3 3
Max: 15m
Approx: 10m
OFF
customer.support@pyronix.com
12 13 14
TAMPER
W = XD-WALLBRACKET
F = XD-FIXEDBRACKET
HIGH
+
+
+
+
HIGH
+
+
+
+
www.pyronix.com
Pyronix Limited, Pyronix House, Braithwell Way, Hellaby, Rotherham, S66 8QY, UK
5
XDH10TT3-WE (UK ONLY)
XDH10TT1-WE
White 10.579Ghz
Pink 9.910Ghz
Blue 9.890Ghz
Green 10.587Ghz
Red
10.595Ghz
Red 9.900Ghz
2
Powering Up / Accensione
TOP PIR ALARM MICROWAVE
Low Battery / Batteria Bassa
Top PIR Activated /
PIR Alto Attivato
Microwave Activated /
Microonda Attivata
Bottom PIR Activated /
PIR Basso Attivato
BOTTOM PIR
Alarm / Allarme
WALK TEST?
LOW
+
+
+
+
LOW
+
+
+
+