Kobalt KDG 124B-03 Manual Del Usuario página 12

OPERATING INSTRUCTIONS
3. Speed Selector
The die grinder has a 3-speed selector (E) located
on the base for grinding at three different speed
(Refer to specifications).
Move the selector to 1, the die grinder provides
lowest speed.
Move the selector to 2, the die grinder provides
medium speed.
Move the selector to 3, the die grinder provides
maximum speed.
Change the speed by sliding the selector for
different applications.
NOTICE: Do not change the speed while the tool is running. The speed range will not change
until you first release the slide switch.
4. LED Worklight
The three LED worklights (B), located on the front
of the die grinder, will illuminate when the slide
switch is turned on. This provides additional light
on the surface of the workpiece for operation in
lower-light conditions.
The LED worklights will turn off approximately 10
seconds after the slide switch is released.
a. The LED worklights will blink rapidly if the
tool has stopped working due to overwork or
overheating; please wait for the tool to cool
down, at which point it can be started again.
b. The LED worklights will blink slowly to indicate
that the battery charge is very low.
3
E
4
B
12
1 2 3