Kobalt KDG 124B-03 Manual Del Usuario página 14

OPERATING INSTRUCTIONS
7. Using with Die Grinder
WARNING
• Always wear safety goggles or safety glasses
with side shields during power tool operation. If
operation is dusty, also wear a dust mask.
Check the accessory before application. Discard
accessories that have been dropped, bumped,
subjected to extreme changes in temperature, or
come into contact with solvents or wetness.
a. Before beginning a period of work, test the tool
by letting it spin for one minute before applying
it to the workpiece.
b. Make sure that the workpiece is firmly clamped
in place.
c. Hold the tool securely with both hands.
d. Start the tool.
NOTICE: If the battery is inserted when the tool switch is in the "ON" position, the tool will not
run. Turn the tool off, then turn it back on to begin work.
e. Allow the accessory to reach full speed before beginning work.
f. Control pressure and surface contact between the accessory and the workpiece.
WARNING
• Never force accessories onto work. Too much pressure will cause the tool to overload and
may result in personal injury.
g. When finished, turn off the tool and make sure it comes to a complete stop before laying it
down.
7
14