Listening through a Receiver
You can listen to sound through a receiver instead of the TV speaker.
1. Press the Anynet+ button.
Press the ▲ or ▼ button to select Receiver, then press the ENTER/OK button.
2. Press the ◄ or ► button to select to On, then press the ENTER/OK button.
Now you can listen to sound through the receiver.
3. Press the EXIT button to exit.
➣
When the receiver is set to On, you can listen to the TV sound through the 2-channel
receiver.
➣
If the receiver is exclusively for a home theater only (supporting audio only), it may not
appear in the device list.
➣
In case of a content with copyright problem, listening through the receiver may not
properly operate.
➣
When listening through the receiver, there are restrictions for using the PIP and audio-related menu.
Check Points before Requesting Service
Symptom
Solution
Anynet+ does not
■
work.
■
■
■
■
■
■
■
■
■
I want to start
■
Anynet+.
■
I want to exit Anynet+. ■
■
■
The Connecting to
Anynet+ device...
■
message appears on
■
the screen.
The Anynet+ device
You cannot use the play function when Plug & Play is in progress.
does not play.
The connected device
■
is not displayed.
■
■
■
■
The TV program
Check whether the antenna jack on the recording device is properly connected.
cannot be recorded.
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.
Connect only one receiver.
Check if the Anynet+ device power cord is properly connected.
Check the Anynet+ device's Video/Audio/HDMI cable connections.
Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
Check whether the TV remote control is in TV mode.
Check whether it is Anynet+ exclusive remote control.
Anynet+ doesn't work at a certain condition. (Searching channels)
When connecting or removing the HDMI cable, please make sure to search devices again or restart your
TV.
Check if the Anynet+ Function of Anynet+ device is set on.
Check if the Anynet+ device is properly connected to the TV and check if the Anynet+ (HDMI-CEC) is set to
On in the Anynet+ Setup menu.
Press the TV button on the TV remote control to switch to TV. Then press the Anynet+ button to show the
Anynet+ menu and select a menu you want.
Select View TV in Anynet+ menu.
Press the SOURCE button on the TV remote control and select a device other than Anynet+ devices.
Press any of CH, CH LIST, PRE-CH, and such to change to the
TV mode. (Note that the channel button operates only when a tuner-embedded Anynet+ device is not
connected.)
You cannot use the remote control when you are configuring Anynet+ or switching to a view mode.
Use the remote control when the Anynet+ setting or switching to view mode is complete.
Check whether or not the device supports Anynet+ functions.
Check whether or not the HDMI cable is properly connected.
Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
Search Anynet+ devices again.
You can connect an Anynet+ device using the HDMI cable only. Some HDMI cables may not support
Anynet+ functions.
English - 2
Air 28
View TV
Select Device
Record
Menu on Device
Device Operation
Receiver
:On
Setup
Move
Enter
Exit