Setting And Using The Alarms; Introduction; Using The Alarm Buttons; Alarm Status Indicators - Bose WAVE RADIO III Guia Del Usuario

Introduction

radio III has two independent alarms, Alarm
®
The Wave
1 and Alarm 2.
Each alarm can be set for:
• Time
• Wake-up source: buzzer or radio
• Volume

Using the Alarm buttons

Using the Alarm buttons on the bottom of the remote
you can setup and operate each alarm:
Press to turn Alarm 1 on or off.
• Press to activate the Alarm Setup
mode and view Alarm 1 settings.
• Press again to view Alarm 2 settings.
• Press again to exit the Alarm Setup
mode.
Press to turn Alarm 2 on or off.

Alarm status indicators

The upper right-hand corner of the display shows the
alarm status indicators if the alarm is set:
Alarm 1
Alarm 2
Example: Alarms 1
and 2 are set
Alarm 1 time
AM
PM
AM
PM
Alarm 2 time
S
ETTING AND

Setting the alarms

You can choose the settings for each alarm by activating
the Alarm Setup mode and displaying the settings for the
alarm you want to change.
To setup Alarm 1 or 2:
1. Press Alarm Setup to activate the Alarm
Setup mode and display the settings for
Alarm 1.
The alarm number and
time start flashing.
Then the display
shows you the current
settings for Alarm 1.
2. Using the Time buttons, set the
alarm time.
3. Select your wake-up source:
• BUZZER is the factory alarm setting.
• Press to choose a radio station.
4. Press Volume up or down to set
the volume level of the selected
wake-up source.
5. Press to enter the Alarm 2 setup mode. Repeat
Steps 2-4 to set up Alarm 2.
6. Press again to exit the Alarm Setup mode.
The alarm you set is turned on and the alarm time
appears on the display:
U A
SING THE LARMS
Flashing
Alarm number
and time
English – 11