Bosch GSA18V-125 Instrucciones De Funcionamiento Y Seguridad página 8

1607000CE4.qxp_GSA18V-125 4/11/17 3:08 PM Page 8
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
Preparing the Saw
BLADE SELECTION
No one blade can be efficient on all cutting
jobs. Different materials require specially
designed blades. Since your reciprocating saw
can cut so many materials, many types of
BOSCH blades are available. Be sure to use
the proper blade to ensure proper cutting
performance.
INSTALLING AND REMOVING A BLADE
Turn the blade change lever 4 approximately
60° in the direction shown and hold it in place.
Slide the saw blade 1 into the saw blade
holder slot 3a. Let go of the lever 4 (Fig. 2).
Make sure the blade is securely locked in
place.
To remove the blade, turn the blade change
lever 4 approximately 60° in the direction
shown while pulling the blade 1 out of the
Slide charged battery pack 10 into the housing
until the battery pack locks into position (Fig.
3).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the tool housing,
should it become loose due to vibration.
To remove the battery pack 10, press the
battery pack release button 10a and slide the
battery pack forward (Fig. 3).
Press the battery pack release button 10a
again and slide the battery pack completely out
of tool housing (Fig. 3).
Assembly
Disconnect battery pack
from tool before making
INSERTING AND RELEASING BATTERY PACK
blade slot. NOTE: be careful, blade may be hot
(Fig. 2).
Make sure that the front
end of the blade extends
through the footplate for the entire stroke
length. Do not use specialty blades that are
very short or those with a significant cant.
Blade must not contact footplate. A blade
which is too short or tilted could jam inside the
foot and snap.
FIG. 2
3a
1
FIG. 3
10a
-8-
4
10