Important Safety Instructions - RIB WIND Instrucciones Para El Uso Y La Instalacion

Pag. 26 di 44

IMPORTANT SAFETY INSTRUCTIONS

WARNING - IT IS IMPORTANT FOR THE SAFETY OF PERSONS
TO FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1¡ - Keep the automatic control (push-button, remote control, etc) out of the reach of children. The
control systems must be installed at a minimum hight of 1.5m from the groundsurface and not
interfere with the mobile parts.
2¡ - Command pulses must be given from sites, where you can see the gate.
3¡ - Use transmitters only if you can see the gate.
4¡ - Warnings: when you have finished reading this instruction booklet, please refer to the RIB
instructions attached for the other precautionary measures against risks connected with the
installation or use of the product. If you have not received these, ask RIB Export Office to send
them immediately.
R.I.B. IS NOT LIABLE for any damage caused by not following the safety regulations and laws at
present in force not being observed during installation.
DOOR INSPECTION
1) Check the dimensions of the actuator and aluminium frame and that
data corresponds to order data.
2) Ensure that the floor is completely level
3) Check that the mains power supply corresponds to specifications for
the actuator input voltage
4) Ensure that the actuator support structure is sufficiently solid to
withstand the weight of the track and door and that it is securely fixed
into position.
5) Check the opening height on both sides of the door
6) Measure the total opening width.
7) Measure the width of the door
8) Measure the height of the door
IMPORTANT SAFETY INSTRUCTION
FOR INSTALLATION
WARNING -INCORRECT INSTALLATION CAN LEAD TO SEVERE INJURY
FOLLOW ALL INSTALLATION INSTRUCTIONS
1¡ - This instruction booklet is exclusively dedicated to specialized staff who are aware of the
construction criteria and of the accident prevention protection devices for motorized gates and
doors (according to the current regulations and laws).
2¡ - To maintain electrical parts safely it is advisable to equip the installation with a differential thermal
magnetic switch (onnipolar with a minimum opening of the contacts of 3mm) and must comply with
the international rules.
3¡ - As for electric cable type and section RIB suggests cable type <HAR> with minimum section of
1,5mm 2 and however respect IEC 364 rule and general national security regulations.