For Your Safety; Operating Tips - Beta 3011 Instrucciones

INSTRUCTIONS FOR USE

For Your Safety

Before using this machinery, please carefully read the instruction manual and strictly follow its
instructions.
Before each operating cycle, make sure that the machinery is in good condition. The
machinery should not be used if the conditions are not safe enough or if any failure has been
reported.
– Do not use the jack beyond its nominal capacity.
– This tool is designed for lifting purposes only.
– Use on surfaces which can provide adequate resistance.
– Immediately support the load with suitable stands (Beta item 3010).
– Put the jack on such surface as recommended by the manufacturer of the machine to lift.
– Use only extensions or connections recommended for the machine to lift by the manufacturer.
– The jack should be operated in a vertical position.
– Do not make any structural change to the jack.
– Do not remove, cover or damage the safety labels; replace them if they are damaged.
– This booklet is an integral part of the jack, and should always be made available to the operator; arrange for a few
preventive copies to be prepared.
– Use only original spare parts.
– Before using the jack, make sure that it is in good condition. Do not use it if you are not sure or are aware of any
damage.
– Misusing the jack may result in serious damage to the equipment and injury to people.
Specifications
Item
Maximum load
Minimum height
Working height
Adjustment height
Maximum height
Weight

Operating Tips

Lifting machinery:
1. Make sure that the jack and the machinery have been placed on a suitable surface.
2. If the machinery is fitted with castors, apply the parking brake or lock the castors.
3. To place the jack correctly, consult the instruction manual of the machinery.
4. Do not overscrew the release valve.
5. Place the operating lever and pump to lift the machinery.
6. Immediately place some stands to support the machinery. Do not work under the machinery if it has been lifted without placing
any stands. The jack is designed to lift the weight; it does not guarantee static maintenance.
7. Slowly unscrew the release valve, to control down speed, until contact is made with the stands.
Lowering machinery
1. Do not overscrew the release valve.
2. Pump to lift the machinery, until it is pulled away from the stands.
3. Remove the stands.
4. Slowly unscrew the release valve, to control down speed, until contact is made between the machinery and the
ground.
ART. 3011 Hydraulic Bottle Jack
3011 T3.5 3011 T5
3.5 T - 7000 lb 5 T - 10000 lb
170 mm - 6-3/4" 203 mm - 8-3/8"
110 mm - 4-3/8" 146 mm - 5-3/4"
86 mm - 3-3/8" 118 mm - 4-5/16"
366 mm 14-1/2" 467 mm - 18-7/16"
3.5 Kg 4.5 Kg
3011 T10
10 T - 20000 lb
220 mm - 8-5/8"
150 mm - 5-7/8"
114 mm - 4-1/2"
484 mm - 19"
7 Kg
4
3011 T15 3011 T20
15 T - 30000 lb 20 T - 40000 lb
230 mm - 9-3/32" 241 mm - 9-1/2"
154 mm - 6-1/16" 165 mm - 6-1/2"
113 mm - 4-7/16" 115 mm - 4-17/32"
497 mm - 19-3/8" 521 mm
9 Kg 13,5 Kg
EN