Samsung RF26 Serie Manual Del Usuario página 20

There are several items that you need to purchase to complete this connection. You
may find these items sold as a kit at your local hardware store.
1/4" compression nut
plastic tubing
1. Tighten the compression nut
- If you are using copper tubing, slip the compression nut
copper tubing (not included) as shown.
- If you are using plastic tubing
compression fitting.
Do not use without the molded end(Bulb) of the plastic tubing
CAUTION
2. Tighten the compression nut
3. Turn water on and check for any leakage.
Only connect the water line to a drinkable water source.
If you have to r
leak-free connection.
2. Remove the fixed cap by turning it counter clockwise.
. 1 Remove the protection cap by turning it counter clockwise.
Keep the cap in a safe place for later use if you don't
Keep the cap in a safe place for later use if you don't
use the filter.
use the filter.
2 Remove the water filter from the box and put a .
replacement indicator sticker on the filter as shown.
Place a sticker on the filter that dates six months in
the future. For example, if you install the water filter in
March, put the "SEP" sticker on the filter to remind you
to replace it in September. That way you'll know when
it is time to replace the filter. Normally, a filter life is
about 6 months.
20_Setting Up
copper tubing pp g
ferrule ferrule
onto the 1/4" compression fitting.
, insert the molded end(Bulb) of the plastic tubing
onto the compression fitting. Do not over-tighten the compression nut
Assembled)
Assembled)
(not included) and ferrule (not included) on
.
1/4" of the plastic tubing to make sure you get a snug,
2
into the
.
3
Sticker
(month indicator)