Installing The Pump - Diemer P1800 RIDICON Manual

3 Installation
3.1 Global installation
Danger:
 Ensure that the appropriate positions are maintained between patient, pump
and extension line.
Warning:

line from being over bent or stretched.
 Syringe should be correct installed on the syringe pump.

3.2 Installing the pump

The pump has a pole clamp on the back that may attach it to the pole of an infusion stand.
Information:
 The pump is designed to be installed on a pole.
 Pole diameter : from 15 to 35 mm.
Warning:
 Placement of the pump on a flat table for infusion is not recommended.
3. Unscrew the pole champ(item
pump is fully secured to the pole.
4. Check that the pump is securely attached.
Warning:
 Ensure the load bearing capacity of the infusion stand is more than 2.5 times the
weight of the device.
 Ensure the device attached infusion stand is positioned securely and stably and
Place the patient on the opposite side of the pusher to protect the extension
), attach to the pole (item
②
), and screw the clamp until
①
75